首页 驱动下载 编程开发 Flash游戏 网络教程 网络技术 手机大全 网络学院 软件下载 网站地图 收藏本站

网络首页

路由技术 交换技术 接入技术 网络建设 网络安全 网络知识 组网建网

CCNA CCNP CCIE Cisco VPN IOS 交换机 路由器

考级认证 相关软件 华为产品 思科产品 在线实验 其它产品 解决方案 架站服务

VLAN 网络安全 服务器 ADSL IT认证 VOIP 网络监控

您现在的位置是:首页 > 网络技术 > 考级认证 > Cisco认证 > CCNA认证 > 正文

注册表专题

文章搜索

网络技术快速导航
分类列表
Cisco 路由配置语句汇总

http://www.pcdog.com 中国思科培训网 2005-9-6 点击数:3903


下一页 1 2 3 4 5 6 

 启动接口,分配IP地址:
  router>

  router> enable

  router#

  router# configure terminal

  router(config)#

  
router(config)# interface Type Port

  router(config-if)# no shutdown

  router(config-if)# ip address IP-Address Subnet-Mask

  router(config-if)# ^z


  配置RIP路由协议:30秒更新一次

  router(config)# router rip

  router(config-if)# network Network-Number <--通告标准A,B,C类网-->

  router(config-if)# ^z


  配置IGRP路由协议:90秒更新一次

  router(config)# router igrp AS-Number <-- AS-Number范围1~65535-->

  router(config-if)# network Network-Number <--通告标准A,B,C类网-->

  router(config-if)# ^z


  配置Novell IPX路由协议:Novell RIP 60秒更新一次

  router(config)# ipx routing [node address]

  router(config)# ipx maximum-paths Paths <--设置负载平衡,范围1~512-->

  router(config)# interface Type Port

  router(config-if)# ipx network Network-Number [encapsulation encapsulation-type] [secondary] <--通告标准A,B,C类网-->

  router(config-if)# ^z


  配置DDR:

  router(config)# dialer-list Group-Number protocol Protocol-Type permit [list ACL-Number]

  router(config)# interface bri 0

  router(config-if)# dialer-group Group-Number

  router(config-if)# dialer map Protocol-Type Next-Hop-Address name Hostname Telphone-Number

  router(config-if)# ^z


  配置ISDN:

  router(config)# isdn swith-type Swith-Type <--配置ISDN交换机类型,中国使用basic-net3-->

  router(config-if)# ^z


  配置Frame Relay:

  router(config-if)# encapsulation frame-relay [cisco | ietf ]

  router(config-if)# frame-relay lmi-type [ansi | cisco | q933a ]

  router(config-if)# bandwidth kilobits

  router(config-if)# frame-relay invers-arp [ Protocol ] [dlci ]

  <--配置静态Invers ARP表:

  router(config)# frame-relay Protocol Protocol-Address DLCI [ Broadcast ] [ ietf | cisco ] [ payload-compress | packet-by-packet ]

  -->

  <--设置Keepalive间隔:

  router(config-if)# keepalive Number

  -->

  <--为本地接口指定DLCI:

  router(config-if)# frame-lelay local-dlci Number

  -->

  <--子接口配置:

  router(config-if)# interface Type Port.Subininterface-Number [ multipoint | point-to-point ]

  router(config-subif)# ip unnumbered Interface

  router(config-subif)# frame-lelay local-dlci Number

  -->

  router(config-if)# ^z



下一页 1 2 3 4 5 6 

推介精选文章 vlan9.com 常用网络命令集精选文章 ADSL modem用户端配置篇 ADSL上网共享篇集合  ADSL用户端故障篇集合 cisco 命令手册--精选文章 华为交换机命令手册 华为路由器配置手册

网络关键字
CCNA CCNP CCIE Cisco VPN 交换机 路由器 VLAN 网络安全 服务器 ADSL VOIP网络电话 局域网

   

| Cisco技术
| Cisco产品
| Cisco认证
| 网络知识
| 华为技术
| 解决方案
| 中兴技术
| NGN技术

 
     

关于我们 | 联系方式 | 合作伙伴 | 版权声明 | 帮助信息 | 网站地图
Copyright 2004-2005 PCdog.com, All Rights Reserved